Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - krollad

Pages: [1]
Shields and Other / FTDI Basic 5/3.3V programmer how to select 3.3V
« on: September 22, 2014, 12:52:16 AM »

Does anyone know how to select 3.3V from this board with code PGM-FTDI-BASIC.
There's a switch on the top which I assumed would change the output from 3.3V to 5V, but it doesn't do anything, the output is 5V regardless of where the switch is.
The sparkfun site talks about soldering a jumper.

Any help would be much appreciated.

Pages: [1]