Author Topic: Contract programmer required for custom Web Server  (Read 6628 times)

Damica

  • Newbie
  • *
  • Posts: 1
    • View Profile
Contract programmer required for custom Web Server
« on: October 20, 2009, 03:48:31 AM »
Below is a letter I sent to Modtronix. Along with there reply! Can someone please Help?

Hello David

All of the requirements you listed can be done, and should only take a
couple of days. We are however not doing any more custom projects at the
moment. We are very busy with our new Presto and DIN range of products. You
could post a mail on our forum, there are many people who have done lots of
work with our boards, and will easily be able to do this simple project.
Maybe something like "Contract programmer required for custom Web Server".
You can post it:
http://forum.modtronix.com/index.php?topic=6.0
and here:
http://forum.modtronix.com/index.php?board=1.0

Regards,
David

=========================================
Modtronix Engineering
Sydney, Australia
Tel: +61 (0)2 9011 8138
Mob: +61 (0)405 353466
Fax: +61 (0)2 82094824
Web: http://www.modtronix.com

----- Original Message -----
From: "dcamp" <[email protected]>
Sent: Monday, October 19, 2009 11:42 PM
Subject: SBC65EC


> Good Morning:
>
> I do a lot of work with Digital I/O over Ethernet. Please let
> me try to explain.
>
> What I need is a cost effective device such as your
> ("SBC65EC"). I have read most of the information about this
> device and can see that it offers most of what I need, but
> not all.
>
> I am not a programming, however I was wondering if this
> could be done with your device and I would pay for the
> program.
>
> Here is a list of what I need.
>
> 16 inputs, that can be set to either "LOW or HIGH" on
> startup. “User Programmable”
> 8 output, that can be set to either "SINK or SOURCE" 5vdc
> (Small current). “User Programmable”
>
> Event trigger that can be set on the INPUTS to control the
> OUTPUTS when an EVENT has occurred. “User Programmable”
>
> EMAIL Event notification when event has happened on
> input.("need to know which input triggered the event")Please
> NOTE: this has to happen even if the trigger event was only
> 100ms in length.
>
> The email setup has to be able to Authentication.
>
> Would like to have some type of a timer on the Output that
> could be set. (Here is what I mean).("Once an input event
> has triggered an output I can control how long the output
> will stay active. Maybe something like 2 sec to 15
> minutes.)This would just be nice to have but could do
> without!
>
> Thank you for your time.
>
> David M. Camp
> [email protected]
>



« Last Edit: October 06, 2014, 05:52:15 PM by modtro2 »