Author Topic: Device Power  (Read 4625 times)

Cyberdisyan

  • Guest
Device Power
« on: November 25, 2004, 07:29:09 AM »
Hi,

I just buy a SBC44EC board. It's the first time that i use this board.
I haven't see at any place in the documentation (or on the board) how to plug the power supply. I mean is the GND in the center pin or outside.

And what is the best voltage? Is 12V enough or good?

Thanks for your replies.

Cyberdisyan

  • Guest
No body in this forum :cry:
« Reply #1 on: November 29, 2004, 07:24:07 AM »
I've found the solution my self ... after having an adrenaline increasing ...

The Center pin is the positive pole.

Aparently the board is protected, if one would invert the tension.