Author Topic: Photo of new im232M RS232 module  (Read 5733 times)


  • Administrator
  • Hero Member
  • *****
  • Posts: 564
    • View Profile
Photo of new im232M RS232 module
« on: February 03, 2008, 10:27:09 PM »
Attached are some photos of our new im232M module. It is part of our new Presto iMod Range. It has press-fit connectors, and is pressed into 1mm holes on the main board. It has a RS232 Interface (via RJ45 connector) with Receive, Transmit, RTS and CTS signals. It works over a wide operating voltage range from 3V to 5V.

We will also be supplying custom cables for connecting this module to a standard D-Sub 9 pin connector. This cable will have a RJ45 plug on one end, and D-Sub 9 pin male connector on the other end.
« Last Edit: February 10, 2008, 03:25:22 PM by modtro2 »


  • Newbie
  • *
  • Posts: 3
    • View Profile
Re: Photo of new im232M RS232 module
« Reply #1 on: September 09, 2011, 04:04:03 AM »
I would like to buy two of those :-)